Parts Inspection Lookup
ID:
Part Number:
Dimension:
Description:
Target:
Upper Limit:
Lower Limit:
Notes:
8-5-08vp (Updated Format): Inspection Criteria 1. Verify 1 pc from each lot per MFT latest drawing. Read ALL notes and past Receiving Inspection History. 2. Verify correct/current Part Number and revision between MFT PO, MFT drawing, supplier packing slip and part markings. 3. Verify material/finish/plating. 4. Closely check all critical dimensions (dimensions within oval on MFT drawing). **8/5/08vp: Due to history of good lots from Cosmos supplier, MFT is pulling 20 pc inspection sample sizes from each lot received vs 35 pc inspection samples size. NOTE: If there are quality issues, the sample size MUST increase to 35 pc sample sizes until history allows a "reduced" or "skip lot" sample. Tools Required: • 1-2” Mitutoyo Micrometer with SPC data cable/Mic Stand optional. • Mitutoyo 3 Point Bore Gage o .65 - .8” Adapter with .79995” Calibration Ring