Parts Inspection Lookup
ID:
Part Number:
Dimension:
Description:
Target:
Upper Limit:
Lower Limit:
Notes:
8-12-08vp: Inspection Criteria 1. Verify 1 pc from each lot per MFT latest drawing. Read ALL notes and past Receiving Inspection History. Watch for excess material in bores. See photos from previous receipt (5/19/08). 2. Verify correct/current Part Number and revision between MFT PO, MFT drawing, supplier packing slip and part markings. 3. Verify material/finish/plating. 4. Closely check all critical dimensions (dimensions within oval on MFT drawing). 5. 4.20 dia: Verify 1st pc diameter then check 100% of parts with 12604 shaft. Shaft MUST be tight (no slop) and cross holes MUST align. 6. Flat: Measure per 1st pc. 7. 16.075mm Bore: Measure in the center of bore. Tools Required: • • 6” Mitutoyo Caliper with SPC data cable. • Mitutoyo 3 Point Bore Gage o .5 - .65” Adapter with .64969” Calibration Ring